Descripción
ENVIAR EMAIL
Withdrawal sleeves can be used to mount bearings with a tapered bore on the cylindrical seat of stepped shafts (). The sleeve is pressed into the bore of the bearing inner ring, which abuts a shaft shoulder or similar fixed component. The sleeve is located on the shaft by a nut or an end plate. Lock nuts or end plates are not supplied with withdrawal sleeves. KM or HM lock nuts (→ ) with appropriate locking devices are suitable, but must be ordered separately.
To press the withdrawal sleeve into the bearing bore, a considerable amount of force is required to overcome the friction between the bearing, sleeve and shaft. To facilitate mounting and dismounting bearings on withdrawal sleeves, SKF recommends using a hydraulic nut ().
CategorÃa de productos Bearings, Units, and Housings Condition monitoring Electric Motor specialist Linear motion Lubrication Solutions Maintenance products (incl. lubricants) Power Transmission Seals Services (Consultancy, Maintenance) Vehicle aftermarket
Más información sobre este producto consulte en: http://www.skf.com/cl/products/bearings-units-housings/bearing-accessories/withdrawal-sleeves/index.html